Product Description

Normac EP200 is a two component, room temperature curing, epoxy based, liquid adhesive.  When catalysed with the appropriate amount of curative yields high strength adhesion when bonding polyethylene to polyethylene, polyethylene to carpet, wood to wood, urethane to concrete etc.

Package Sizes


Packaged/Sold by Weight


Appearance Mixed Solids Content
Clear amber, brushable liquid. 100%


Chemical Resistance Oil Resistance
Excellent Excellent


Specific Gravity
2500 - 4500 cps


Flammability Shelf Life
Catalysed Normac EP200 is a non-flammable product. >2 years (in unopened containers)


Operating Temperature Application Life
-40oC to 65oC (-40oF to 150oF) 4 - 6 hours @ 21oC (70oF)


Store at ambient temperatures, out of sunlight, away from heat, sparks and flame.

Safety, Handling and Toxicity

See Normac EP200 and EP200H Material Safety Data Sheet (MSDS) for specific handling, safe working practices and specific hazards.


Part A - Material Safety Data Sheet

Part B - Material Safety Data Sheet


For best adhesion, be sure surfaces to be bonded are free from dirt, oil grease and other contaminants.  Roughen the surface of polyethylene with medium grit sand paper (#40), carpet and wood do not require roughening.  Clean sanding residue.  Flame treat the polyethylene with a propane torch by lightly passing the flame over the area to be bonded.  Specifically use the blue portion of the flame to contact the polyethylene.  DO NOT burn or char it.  Wipe clean with Methyl Ethyl Ketone (MEK), Acetone, Toluol or Xylene.  Mix the appropriate amount of EP200 to  EP200H (see ratio).  Mix thoroughly.  Scrape sides and bottom to ensure good mixing.  Apply enough mixed EP200 to both surfaces.  Usually 125 to 250 microns (.005" to 0.10") is sufficient to wet out the bonding surfaces.  Clamp or hold bonding surfaces together for 6 - 8 hours.  DO NOT  apply excessive pressure as this may force out adhesive. Allow to cure minimum 16 to 24 hours prior to use.


Do not dilute.


15.5 m2  per kg. (166.67 ft.2  per lb.) at .001" . Theoretical yield.   Recommended thickness is .010".



Product Menu  





© Normac Adhesive Products Inc.